Self Aligning Ball Bearings
This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.
However, depending on the surrounding structure, such an angle may not be possible.
- 80 mm x 140 mm x 33 mm SKF 2216ETN9 self aligning ball bearings
- Cast Iron
- 0 Inch | 0 Millimete
- 90 mm x 160 mm x 30 mm NSK 1218 self aligning ball bearings
- 0,0072 Kg
- 22 mm
- 85 mm x 150 mm x 28 mm NKE 1217 self aligning ball bearings
- Cast Iron
- 0 Inch | 0 Millimete
- 30 mm x 72 mm x 27 mm SIGMA 2306 self aligning ball bearings
- 0,0072 Kg
- 22 mm
- 35 mm x 72 mm x 23 mm NACHI 2207 self aligning ball bearings
- 0,0072 Kg
- 22 mm
- 20 mm x 47 mm x 18 mm ISB 2204-2RSTN9 self aligning ball bearings
- Cast Iron
- 0 Inch | 0 Millimete