Self Aligning Ball Bearings
This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.
However, depending on the surrounding structure, such an angle may not be possible.
- 25 mm x 62 mm x 17 mm ISB 1305 TN9 self aligning ball bearings
- 120x55x29
- 143 kN
- Toyana 2218 self aligning ball bearings
- 290 mm
- 230 mm
- 25 mm x 62 mm x 24 mm ISO 2305-2RS self aligning ball bearings
- 0,0072 Kg
- 22 mm
- 25 mm x 52 mm x 18 mm KOYO 2205K self aligning ball bearings
- Cast Iron
- 0 Inch | 0 Millimete
- Toyana 1206K+H206 self aligning ball bearings
- 170 mm
- 205 mm