Self Aligning Ball Bearings
This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.
However, depending on the surrounding structure, such an angle may not be possible.
- 70 mm x 150 mm x 35 mm NKE 1314 self aligning ball bearings
- 120x55x29
- 143 kN
- 80 mm x 140 mm x 26 mm ISB 1216 K self aligning ball bearings
- 0,0072 Kg
- 22 mm
- 30 mm x 62 mm x 20 mm FAG 2206-K-TVH-C3 self aligning ball bearings
- 120x55x29
- 143 kN
- 55 mm x 120 mm x 29 mm ISO 1311K self aligning ball bearings
- Cast Iron
- 0 Inch | 0 Millimete
- 40 mm x 80 mm x 18 mm SKF 1208EKTN9 self aligning ball bearings
- 18800 N / Static loa
- 28,4 g / Weight
- AST 2204 self aligning ball bearings
- 18800 N / Static loa
- 28,4 g / Weight
- 30 mm x 62 mm x 20 mm SKF 2206E-2RS1TN9 self aligning ball bearings
- Cast Iron
- 0 Inch | 0 Millimete